Case Studies & Field Reports

Vibratory sifting improves brownie throughput

October 1, 2011
/ Print / Reprints /
ShareMore
/ Text Size+
Brownie baker upgrades its homebrew screener to keep up with increasing orders.

Particles larger than 0.25- x 0.25-in. square discharge through an upper spout, on-size particles move through lower spout. Source: Kason.


Greyston Bakery has an unusual history for a commercial bakery. It was founded in 1982 as the for-profit arm of the Greyston Foundation, which uses the bakery’s earnings to fund community development initiatives. Greyston Bakery has been baking brownies for blending with ice cream since 1988. Since then, it has grown into one of the industry’s top suppliers, producing more than 20,000 lbs. of ice cream mix-ins daily.

“Our 23,000 sq.-ft. facility is in an urban location where storage is at a premium, so we keep only minimal inventories. Every step of the production process needs to keep up the pace. We ship them as fast as we cook them,” adds Vincent Lombardo, plant engineer.

After mixing, baking, cooling and sizing brownies, pieces intended for single-serve cups move to the vibratory screener, where chunks larger than 0.25 in. x 0.25 in. are removed. Greyston’s first vibratory screener was a tray-in-a-tray box model driven by two rotary air vibrators built in-house by Lombardo. It was unable to keep up with the flow of production.

“It was not robust enough to handle 20 hours per day of production,” Lombardo says. “We considered going with either a rotary or a vibratory screener. We eventually decided on the circular vibratory screener because of its low maintenance requirements, screen longevity, capacity and price.”

Lombardo specified a 24-in. diameter Vibroscreen circular vibratory screener from Kason Corporation. The gravity-fed, food-grade unit is driven by a single, low-horsepower, 230-volt three-phase, imbalanced-weight gyratory motor mounted in an enclosed cage directly beneath the screening chamber. Due to height limitations, the Vibroscreen screener is limited to one screen deck, yet it meets throughput requirements while offering reserve capacity.

When the brownies enter the screener, multi-plane inertial vibration of the nylon screen causes the 0.25-in. square pieces to fall through its apertures. Larger chunks are transported across the screen surface along controlled pathways into the discharge spout, which ejects them onto a conveyor that takes them for regrinding.

“We opted for only one screen, since we’re more concerned with removing oversized pieces than removing any fines that were not removed by the tumbler,” says Lombardo. “If we needed to, we could drop the 0.25-in. square pieces onto a 10 mesh screen and remove any fines that fell through.”  Instead, the 0.25-in. square pieces drop onto a pan and exit past a vertical metal detector. If the detector senses any slivers of metal in the brownies, the batch is discharged automatically through a cylinder-activated chute and discarded.

While blinding is not an issue, the screener requires daily cleaning. “We run production for 20 hours, then shut down for four hours to clean the whole system,” says Lombardo. “The motor and connector box are watertight, so we can rinse down the interior and exterior with a hose, apply a foaming cleanser and then rinse it down again,” he explains. 


For more information:

Henry Alamzad, Kason Corporation, 973-467-8140 or info@kason.com

Did you enjoy this article? Click here to subscribe to Food Engineering Magazine.

You must login or register in order to post a comment.

Multimedia

Videos

Image Galleries

Fabulous Food Plant: Paramount Citrus

Learn more about this fabulous food plant in Food Engineering's article, found here.

Podcasts

Burns & McDonnell project manager RJ Hope and senior project engineer Justin Hamilton discuss the distinctions between Food Safety and Food Defense as well as the implications for food manufacturers of the Food Safety Modernization Act.
More Podcasts

THE MAGAZINE

Food Engineering Magazine

Food engineering magazine 2014 april cover

2014 April

Catch a preview of the Powder and Bulk Show in this April 2014 edition of Food Engineering. Also, be sure to check out a coffee stick making a real stir and a major advancement in the the pet food industry.
Table Of Contents Subscribe

THE FOOD ENGINEERING STORE

Food-Authentication-Flyer-(.gif
Food Authentication Using Bioorganic Molecules

This text provides critical tools and data needed to augment routine food analysis and enhance food safety by aiding in the detection of counterfeit, and potentially deleterious, foods.

More Products

Clear Seas Research

Clear Seas ResearchWith access to over one million professionals and more than 60 industry-specific publications,Clear Seas Research offers relevant insights from those who know your industry best. Let us customize a market research solution that exceeds your marketing goals.

Food Master

Food Master Cover 2014Food Master 2014 is now available!

 

Where the buying process begins in the food and beverage manufacturing market. 

Visit www.foodmaster.com to learn more.

STAY CONNECTED

FE recent tweets

facebook_40.pngtwitter_40px.pngyoutube_40px.pnglinkedin_40px.png