Dry Processing

Fluid bed drying system

By Wayne Labs, Senior Contributing Technical Editor

Kason’s Vibro-Bed circular fluid bed drying system integrates a 30-in. (762mm) diameter fluid bed processing chamber with an electric heater, blower and control panel on 2 shippable frames ready for onsite connection to a power source, dust collector and material inlet/outlet. Reductions in material, weld seams and associated labor decrease fabrication cost when units are finished to FDA, USDA, BISSC or 3-A standards. Stainless steel material contact surfaces reduce cleaning time.

Kason Corporation; 973-467-8140; www.kason.com

KEYWORDS: drying

Looking for a reprint of this article?
From high-res PDFs to custom plaques, order your copy today!

Wayne Labs has more than 30 years of editorial experience in industrial automation. He served as senior technical editor for I&CS/Control Solutions magazine for 18 years where he covered software, control system hardware and sensors/transmitters. Labs ran his own consulting business and contributed feature articles to Electronic Design, Control, Control Design, Industrial Networking and Food Engineering magazines. Before joining Food Engineering, he served as a senior technical editor for Omega Engineering Inc. Labs also worked in wireless systems and served as a field engineer for GE’s Mobile Communications Division and as a systems engineer for Bucks County Emergency Services. In addition to writing technical feature articles, Wayne covers FE’s Engineering R&D section.